![]() ![]() A key prefix is similar to a directory name that enables you to store similar data under the same directory in an S3 bucket. Key prefix for the Quick Start assets S3 bucket. It cannot start or end with a hyphen (-).ĪWS Region where the Quick Start assets S3 bucket (QSS3BucketName) is hosted. ![]() It can include numbers, lowercase letters, uppercase letters, and hyphens (-). AWS Quick Start configuration Parameter label (name) The default addresses listed are BitBucket Cloud IP ranges.Ĭhoose False to omit the. If a webhook payload header contains a matching secret, IP address authentication is bypassed. Git pull settings Parameter label (name)ĪPI secret used to authenticate access to webhooks in GitHub Enterprise, GitLab, and other Git services. If left blank, API Gateway creates a domain name for you. ![]() If left blank, the Quick Start creates one for you.ĭomain name for the webhook endpoint. (Optional) Name for the S3 bucket where the Git repository. I decided I did not really want to mess with it any longer, because things seemed kind of flaky and unrealiable - but that was obviously just my experience - I gave up after how easy the gopro worked.Parameters for deploying into your selected Region Table 1. I did not end up liking my setup though, atleast not once I got my gopro, so I returned the Git2. They have the free designs cataloged and the websites software does all the 3D printing calculations automatically (even lets you know if the part will not print correctly) and you do not have to get into all the nitty gritty of 3D printing stuff. The parts turned out really well and I got um relatively cheap because I ordered several parts at the same time all with the same base specs (color, fill-ratio, etc.) so I was only charge one $10 setup fee (the parts themselves cost anywhere from $1.50 - $6 depending on what I was buying and how many I was ordering. The 3D printed parts are available and i purchased from "", their 3D Co-OP-like printing service. The stock solo gimbal HDMI connector works on this camera after you cut away a bit of the plastic underneath the connector - careful not to slice into the rubber covering the HDMI cable as I did, nearly slicing the wire, making my backup gimbal useless. The gimbal functions as smooth as it did with a GoPro. The fact that the Git2P weighs 23grams less than the GoPro Hero 4 Black helps. I was worried the gimbal would have a problem with the new camera sitting a quarter of an inch forward but it was not a problem. A small amount of trimming of plastic corner under the HDMI cable solved this problem. The HDMI cable was a couple of mm to short to plug into the camera. Velcro is simple and secure plus it makes it easy to change cameras. I use a Velcro strap to hold the camera in place. Then I carefully cut off the rounded tab, on the left side, that was used to hold a GoPro, but was now in the way. Since the GIT2P has to sit in front of the connector, I made a quarter inch thick pad for the camera to rest against (see photo), using the black dense foam that came with the gimbal. I did not want to remove it, because I still want to be able to use it with a GoPro. The first problem I had to deal with was the connector that plugs into the back of a GoPro. ![]() Use of this camera required some modifications to the SOLO gimbal, but I made sure that I can still use a GoPro if I want. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |